QuikBlade^® Meets or Exceeds
ASTM Specifications

1. Release

• Relieve tension using the QuikBlade^® Torque Limiting Driver. Rotate the wrench in a counterclockwise direction.

Remove the BladeStrip from the heel end first...


then the toe.
Reverse this sequence when installing a
new BladeStrip.

2. Replace

• Remove the old BladeStrip, heel first (through the slot).
• Dispose of it properly.
• Inspect the skate rocker for damage and clean if it is necessary.
• Install the new BladeStrip, toe end first
  (as marked).
• Slide the heel end of the BladeStrip through the slot in the heel of skate.

Remember to always install
QuikBlade^® BladeStrips
BEFORE you put your skates on.

3. Re-tension

• Apply light tension using the QuikBlade^® Torque Limiting Driver.
• Inspect the BladeStrip for proper seating.
• Continue tensioning until the driver clicks

It is important that you do not over tension your blades. If your driver doesn't "click" see your local pro shop for a replacement

Re-tension using the QuikBlade^® Torque Limiting Driver